I am loading a mesh, this mesh will be invisible, so I want to only detect collision with it, other meshes should be able to intersect with it, the only purpose is to detect collision.

I'm able to detect collision but the mesh is treated as physical mesh and other meshes can't intersect with it.

How do I make the mesh intersectable? I want to ONLY detect collision

Here is the code I'm using:
btConvexHullShape* invisibleShape = new btConvexHullShape((btScalar*)btVertices, numVertices, sizeof(btVector3));
btAlignedObjectArray<btCollisionShape*> collisionShapes;
collisionShapes.push_back(invisibleShape);
btTransform groundTransform;
groundTransform.setIdentity();
groundTransform.setOrigin(btVector3(0.0f,0.0f,0.0f));
btScalar mass(.0);
//rigidbody is dynamic if and only if mass is non zero, otherwise static
bool isDynamic = (mass != 0.f);
btVector3 localInertia(0,0,0);



if (isDynamic)
invisibleShape->calculateLocalInertia(mass,localInertia);
btDefaultMotionState* myMotionState = new btDefaultMotionState(groundTransform);
btRigidBody::btRigidBodyConstructionInfo rbInfo(mass,myMotionState,invisibleShape,localInertia);
btRigidBody* body = new btRigidBody(rbInfo);
dynamicsWorld->addRigidBody(body);



Resolved after using the flag btRigidBody::CF_NO_CONTACT_RESPONSE, now I want to exclude the mesh from raycasting, how can I do that?

Take a look at btGhostObject .

How can I load a sphere into btGhostObject?

btGhostOjbect inherits, like btRigidBody, from btCollisionObject, therefore you can set a collision shape the same way as when using a btRigidBody.

I know that, but usually I initialize btRigidBody by giving information about the mesh, such as the radius if it's a sphere, how can I make the following sphere btGhostOjbect?
btSphereShape *sphere = new btSphereShape(500.0f);

as both btGhostObject and btRigidBody derive from btCollisionObject you can just do :

btSphereShape *sphere = new btSphereShape(500.0f);
btGhostObject* ghost = new btGhostObject();
ghost->setCollisionShape(sphere);

(which you could also do on the rigid body rather than setting the collision shape in the btRigidBodyConstructionInfo and passing that to the btRigidBody ctor.

make sure you do all this before adding it to the collisionWorld though.

Thanks!